Reconfigure Networking

By default, the PTK will be configured to use DHCP. The PTK has an Alt+r hotkey which will allow you to reconfigure the network settings.

DHCP to Static reconfiguration

  1. From the kiosk, press the Alt+r hotkey to expose the Reconfiguring PTK Settings wizard.

  2. Type static and hit the Enter key.

  3. Type the IPv4 address for the PTK and hit the Enter key.

  4. Type the Netmask for the PTK and hit the Enter key.

  5. Type the default Gateway for the PTK and hit the Enter key.

  6. Type the IP address of a DNS Server for the PTK and hit the Enter key.

  7. At this point networking will restart. Hit the Enter key to close the wizard. Within five minutes the networking configuration should be completely refreshed on the kiosk screen.

Static to DHCP reconfiguration

  1. From the kiosk, press the Alt+r hotkey to expose the Reconfiguring PTK Settings wizard.

  2. Hit the Enter key to accept the default answer of dhcp OR type dhcp and hit the Enter key.

  3. At this point networking will restart. Hit the Enter key to close the wizard. Within five minutes the networking configuration should be completely refreshed on the kiosk screen.

Troubleshooting

Job for networking.service failed at the end of wizard

The following error sometimes appears at the end of the Reconfiguring PTK Settings! wizard, but it is usually benign. However, if after five minutes the kiosk does not reflect the input you specified in the wizard, please try restarting the PTK.